Alpine A110 1300 Routes of cables etc

[Swedishengineer]

A110 1300
I am seeking photos of the routes of cables pipes etc under the car i.e
fuel lines
brake lines
heater hoses
throttle cable clutch cable and anything else .
To give me the best method of locating and fixing the tubes etc

it may obvious to some but it is best to seek advice to get a better idea

[Swedishengineer]

Surely someone out there has some photos or diagrams

come on chaps


Certainement quelqu'un a des images ou des diagrammes

viens sur les chaps

[Mail0183]

hello
you should contact my friend dondini at this address

www. dondini.de
regards

[Swedishengineer]

tried contact with no success

so listed new post see above

[BonnA110]

Alpine A110 1300 (V85) - No GORDINI ( Carburator inplanted on the left of the engine - Important for carburator cable )

Passage-cables-platine-AR.jpg

Chassis-demontage.jpg

Chassis-remontage---001.jpg

Chassis-remontage---002.jpg

[BonnA110]

For fuel :


viewtopic.php?f=7&t=33025&hilit=tuyau+essence

[Swedishengineer]

Thank you for the response this is most useful

I will study and advise how i get on.

I hope I am successful as the chassis was attached to the body before the cables etc were fitted . I hope i can manage to fit them now .

How was it done in the factory I wonder
..................................................................................
Merci pour la réponse c'est très utile

J'étudierai et conseillerai comment je continue.

J'espère que je réussis car le châssis était attaché à la carrosserie avant que les câbles, etc. ne soient installés. J'espère que j'arriverai à les monter maintenant.

Comment c'était fait à l'usine je me demande

[Swedishengineer]

questions

Chassis-remontage---001.jpg

where are the cable from battery to alternator and starter motor

[BonnA110]

The battery positive cable is on the left along the center principal tube , positionned at the same heignt from the floor.

The choke cable is behing the driver seat.

Starter.jpg

[PhL]

Splendides ces photos, j'en ai piqué une pour l'article du maître cylindre http://loutrel.org/Maitre.php

[PepeSX]

Splendides ces photos, j'en ai piqué une pour l'article du maître cylindre http://loutrel.org/Maitre.php

C'est sur que là il n'y a pas nécessité d'avoir de mains homme-sage

[Swedishengineer]

With reference to photos shown

can you tell me if the pipes shown on one photo is the fuel line

it is seen on one picture but not the other


En référence aux photos présentées

pouvez-vous me dire si les tuyaux montrés sur une photo sont la conduite de carburant

ça se voit sur une photo mais pas sur l'autre

Chassis-remontage---002.jpg

[BonnA110]

No, it's brake rear pipe.
The fuel pipe is on the body, not on the châssis.

[PhL]

The fuel line ( copper tube) on both 1300 and 1600 are the same.

It goes from the left of the tank down to above the steering rack.
Then it crosses to the right of the car and all along the body, finishing on the right .
Then it becomes a rubber hose.
This was perfect for the 1300 and its carburetors, but is awkward for the 1600: the hose has to be knitted in the chassis to reach the left side of the car.

[BonnA110]

Fuel pipe :

img_2810.jpg

[PhL]

Thanks BonnA110 for correcting the start of the pipe:

it starts from the center below the tank .

I forgot that I had modified this circuit when mounting my home-made fuel injection.
http://loutrel.org/Injection.php

injection pompe et filtre.jpg